Creating Ipv6 Is-Is Processes - Huawei S6700 Series Configuration Manual

S6700 Series Ethernet Switches
Configuration Guide - IP Routing

6.11.2 Creating IPv6 IS-IS Processes

Before configuring basic IPv6 IS-IS functions, create IPv6 IS-IS processes and then enable IPv6
IS-IS interfaces.
Context
To create an IPv6 IS-IS process, perform the following operations:
l
l
l
l
Procedure
l
Issue 01 (2012-03-15)
Create an IS-IS process and configure the NET of a device.
(Optional) Configure the level of a device.
The level of a device is level-1-2 by default.
Configure the device level based on the network planning. If no device level is configured,
IS-IS establishes separate neighbor relationships for Level-1 and Level-2 devices and
maintains two identical LSDBs, consuming excessive system resources.
(Optional) Configure IS-IS host name mapping.
After IS-IS host name mapping is configured, a host name but not the system ID of a device
will display by using display commands. This configuration improves the maintainability
on an IS-IS network.
(Optional) Enable the output of the IS-IS adjacency
If the local terminal monitor is enabled and the output of the IS-IS adjacency status is
enabled, IS-IS adjacency changes will be output to the router until the output of the
adjacency status is disabled.
Create an IS-IS process and configure the NET of a device, enable IPv6 for the process.
1. Run:
system-view
The system view is displayed.
2. Run:
isis [ process-id ]
An IS-IS process is created, and the IS-IS process view is displayed.
The process-id parameter specifies the ID of an IS-IS process. The default value of
process-id is 1. To associate an IS-IS process with a VPN instance, run the isis
[ process-id ] [ vpn-instance vpn-instance-name ] command.
3. Run:
network-entity net
A NET is configured.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 IS-IS Configuration
status.
285