Configuration Examples; Example For Configuring Basic Ospf Functions - Huawei S6700 Series Configuration Manual

S6700 Series Ethernet Switches
Configuration Guide - IP Routing
l
----End

4.14 Configuration Examples

This section provides several configuration examples of OSPF.

4.14.1 Example for Configuring Basic OSPF Functions

Networking Requirements
As shown in
Switch A and Switch B serve as ABRs to forward routes between areas.
After the configuration, each Switch should learn the routes to all network segments from the
AS.
Figure 4-5 Networking diagram of basic OSPF configurations
Switch
Switch A
Switch A
Switch B
Switch B
Switch C
Switch C
Switch D
Switch D
Switch E
Issue 01 (2012-03-15)
Run the reset gtsm statistics all command in the user view to clear the GTSM statistics
on the board.
Figure 4-5, all switches run OSPF, and the entire AS is partitioned into three areas.
Switch A
XGE 0/0/2
Switch C
XGE 0/0/1
Area 1
XGE 0/0/2
XGE 0/0/1
Switch E
Interface
XGE0/0/1
XGE 0/0/2
XGE 0/0/1
XGE 0/0/2
XGE 0/0/1
XGE 0/0/2
XGE 0/0/1
XGE 0/0/2
XGE 0/0/1
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Area 0
XGE 0/0/1
XGE 0/0/1
XGE 0/0/1
Area 2
XGE 0/0/2
4 OSPF Configuration
Switch B
XGE 0/0/2
Switch D
XGE 0/0/1
Switch F
VLANIF Interface IP Address
VLANIF 10 192.168.0.1/24
VLANIF 20 192.168.1.1/24
VLANIF 10 192.168.0.2/24
VLANIF 30 192.168.2.1/24
VLANIF 20 192.168.1.2/24
VLANIF 40 172.16.1.1/24
VLANIF 30 192.168.2.2/24
VLANIF 50 172.17.1.1/24
VLANIF 40 172.16.1.2/24
136