Huawei S6700 Series Configuration Manual page 309

S6700 Series Ethernet Switches
Configuration Guide - IP Routing
l
l
l
Issue 01 (2012-03-15)
There is no limit on costs of interfaces or route costs. The cost of a route received
by an interface is the actual cost.
– If the cost style is wide-compatible or wide, the cost of the interface ranges from 1 to
16777215. When the cost is 16777215, the neighbor TLV generated on the link cannot
be used for route calculation but for the transmission of TE information. The maximum
cost of a received route is 0xFFFFFFFF.
Configure the cost of an IS-IS interface.
1. Run:
system-view
The system view is displayed.
2. Run:
interface interface-type interface-number
The interface view is displayed.
3. Run:
isis ipv6 cost cost [ level-1 | level-2 ]
The cost of the IS-IS interface is configured.
You can use the isis ipv6 cost command to configure the cost of a specified interface.
Configure the global IS-IS cost.
1. Run:
system-view
The system view is displayed.
2. Run:
isis [ process-id ]
The IS-IS view is displayed.
3. Run:
ipv6 circuit-cost cost [ level-1 | level-2 ]
The global IS-IS cost is configured.
You can use the ipv6 circuit-cost command to configure the costs of all interfaces at
a time.
Enable IS-IS to automatically calculate interface costs.
1. Run:
system-view
The system view is displayed.
2. Run:
isis [ process-id ]
The IS-IS view is displayed.
3. Run:
ipv6 bandwidth-reference value
The reference value of the bandwidth is configured. By default, the bandwidth
reference value is 100 Mbit/s.
4. Run:
ipv6 auto-cost enable
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 IS-IS Configuration
290