Huawei S6700 Series Configuration Manual page 343

S6700 Series Ethernet Switches
Configuration Guide - IP Routing
Figure 6-4 Networking diagram for configuring IS-IS route convergence
Switch A
Switch
SwitchA
SwitchB
SwitchB
SwitchC
SwitchC
SwitchC
SwitchC
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
Issue 01 (2012-03-15)
L2
XGE 0/0/2
XGE 0/0/1
Area 20
Interface
XGE 0/0/1
XGE 0/0/1
XGE 0/0/2
XGE 0/0/1
XGE 0/0/2
XGE 0/0/3
XGE 0/0/4
Enable basic IS-IS functions on each Switch so that the Switches can be interconnected.
Check the IS-IS routing table of SwitchA.
Configure route convergence on SwitchB.
VLAN ID of each interface, as shown in
IP address of each VLANIF interface, as shown in
System ID, level, and area ID of each Switch
– SwitchA: The system ID is 0000.0000.0001; the area ID is 20; the level is Level-2.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Area 10
XGE 0/0/2
XGE 0/0/1
XGE 0/0/1
Switch B Switch C
L1/L2 L1
Figure 6-4
6 IS-IS Configuration
network 1
172.1.1.0/24
XGE 0/0/3
XGE 0/0/4
network 3
172.1.3.0/24
VLANIF Interface IP Address
VLANIF 50 172.2.1.1/24
VLANIF 10 172.1.4.2/24
VLANIF 50 172.2.1.2/24
VLANIF 10 172.1.4.1/24
VLANIF 20 172.1.1.1/24
VLANIF 30 172.1.2.1/24
VLANIF 40 172.1.3.1/24
Figure 6-4
network 2
172.1.2.0/24
324