Configuration Examples; Example For Configuring Ospfv3 Areas - Huawei S6700 Series Configuration Manual

S6700 Series Ethernet Switches
Configuration Guide - IP Routing
Context
The OSPFv3 adjacency is removed when you reset the OSPFv3 connection by using the reset
ospfv3 command. Exercise caution when running this command.
After modifying the OSPFv3 routing policy or protocol, reset the OSPFv3 connection to validate
the modification. To reset OSPFv3 connections, run the following reset ospfv3 command in the
user view.
Procedure
l
----End

5.12 Configuration Examples

This section provides several configuration examples of OSPFv3.

5.12.1 Example for Configuring OSPFv3 Areas

Networking Requirements
As shown in
areas. Switch B and Switch C serve as ABRs to forward the inter-area routes.
You need to configure Area 2 as a stub area. The LSAs advertised to this area can thus be reduced,
without affecting the reachability of routes.
Issue 01 (2012-03-15)
CAUTION
To validate the new configuration, run the following commands:
– reset ospfv3 { process-id | all } [ graceful-restart [ extend-period period ] ]
– reset ospfv3 { process-id | all } counters [ neighbor [ interface-type interface-
number ] [ router-id ] ]
Figure 5-1, OSPFv3 is enabled on all Switches and the AS is divided into three
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 OSPFv3 Configuration
213