S6700 Series Ethernet Switches
Configuration Guide - IP Routing
Pre-configuration Tasks
Before configuring the switch to control the advertising of RIP routing information, complete
the following tasks:
l
l
Data Preparation
To control the advertising of RIP routing information, you need the following data.
No.
1
2
3
2.5.2 Configuring RIP to Advertise Default Routes
A default route is a route destined for 0.0.0.0. By default, RIP does not advertise default routes
to its neighbors.
Context
Do as follows on the RIP switch:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
rip [ process-id ]
The RIP process is enabled and the RIP view is displayed.
Step 3 Run:
default-route originate [ cost cost | { { match default | route-policy route-policy-
name } [
RIP is configured to generate a default route only if route permitted by the route policy is present
as active in the routing table.
----End
2.5.3 Disabling an Interface from Sending Update Packets
Disabling interfaces from sending Update packets is a method of preventing routing loops and
can be implemented in two ways.
Issue 01 (2012-03-15)
Configuring IP addresses for interfaces to ensure that neighboring nodes are reachable at
the network layer
Configuring Basic RIP Functions
Data
Metric of the default route to be advertised
Number of the interface that is suppressed from sending RIP Update packets
Protocol name and process ID of the external route to be imported
avoid-learning
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
*
] } ]
2 RIP Configuration
33