Huawei S6700 Series Configuration Manual page 358

S6700 Series Ethernet Switches
Configuration Guide - IP Routing
Figure 6-7 Networking diagram of IS-IS GR configuration
SwitchA
Switch
SwitchA
SwitchB
SwitchC
SwitchC
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
Procedure
Step 1 Configure VLANs that the related interfaces belong to.
<Quidway> system-view
[Quidway] sysname SwitchA
[SwitchA] vlan 10
[SwitchA-Vlan10] quit
[SwitchA] interface xgigabitethernet 0/0/1
[SwitchA-XGigabitEthernet0/0/1] port hybrid pvid vlan 10
[SwitchA-XGigabitEthernet0/0/1] port hybrid untagged vlan 10
[SwitchA-XGigabitEthernet0/0/1] quit
The configurations of Switch B and Switch are similar to the configuration of Switch A, and
are not mentioned here.
Step 2 Assign an IP address to each VLANIF interface.
Issue 01 (2012-03-15)
SwitchC
L1/L2
L1
XGE0/0/1
XGE0/0/1
Interface
XGigabitEthernet0/0/1
XGigabitEthernet0/0/1
XGigabitEthernet0/0/1
XGigabitEthernet0/0/2
Enable IS-IS on each Switch so that the Switches can be interconnected.
Configure GR in the IS-IS view on each Switch and configure the same interval for the
restart.
ID of the VLAN that each interface belongs to, as shown in
IP address of each VLANIF interface, as shown in
System ID, level, and area ID of each Switch :
– Switch A: The system ID is 0000.0000.0001; the area ID is 10; the level is Level-1.
– Switch B: The system ID is 0000.0000.0002; the area ID is 10; the level is Level-2.
– Switch C: The system ID is 0000.0000.0003; the area ID is 10; the level is Level-1-2.
Restart interval
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
SwitchB
L2
XGE0/0/2
XGE0/0/1
VLANIF interface
VLANIF 10
VLANIF 20
VLANIF 10
VLANIF 20
Figure 6-7
6 IS-IS Configuration
IP address
100.1.1.1/24
100.2.1.2/24
100.1.1.2/24
100.2.1.1/24
Figure 6-7
339