Huawei S6700 Series Configuration Manual page 248

S6700 Series Ethernet Switches
Configuration Guide - IP Routing
Figure 5-4 Networking diagram for configuring OSPFv3 GR
SwitchA
1.1.1.1
Device name
Switch A
Switch B
Switch B
Switch C
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
l
Procedure
Step 1 Add interfaces to VLANs.
<Quidway> system-view
[Quidway] sysname SwitchA
[SwitchA] vlan 10
[SwitchA-vlan10] quit
[SwitchA] interface XGigabitEthernet 0/0/1
[SwitchA-XGigabitEthernet0/0/1] port hybrid pvid vlan 10
[SwitchA-XGigabitEthernet0/0/1] port hybrid untagged vlan 10
[SwitchA-XGigabitEthernet0/0/1] quit
The configurations of Switch B and Switch C are similar to the configuration of Switch A and
are not mentioned here.
Issue 01 (2012-03-15)
VLANIF10 VLANIF10
1000::1/64 1000::2/64
XGE0/0/1
XGE0/0/1
Interface
XGE0/0/1
XGE0/0/1
XGE0/0/2
XGE0/0/1
Configure IPv6 addresses for interfaces.
Enable the basic OSPFv3 functions on each Switch.
Enable the OSPFv3 helper in the OSPFv3 view of Switch B.
Enable the OSPFv3 GR in the OSPFv3 view of Switch A.
IPv6 addresses of the interfaces
Process ID of the OSPFv3 protocol
Router ID (1.1.1.1) of Switch A and area (Area 0) where Switch A is located
Router ID (2.2.2.2) of Switch B and area (Area 0) where Switch B is located
Router ID (3.3.3.3) of Switch C and area (Area 0) where Switch C is located
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
VLANIF20
VLANIF20
2000::1/64
2000::2/64
XGE0/0/2
XGE0/0/1
SwitchB
2.2.2.2
VLANIF interface
VLANIF 10
VLANIF 10
VLANIF 20
VLANIF 20
5 OSPFv3 Configuration
SwitchC
3.3.3.3
IP address
1000::1/64
1000::2/64
2000::1/64
2000::2/64
229