Checking The Configuration; Configuring A Route Multi-Instance Between An Mce And A Site; Establishing The Configuration Task - Huawei S6700 Series Configuration Manual

S6700 Series Ethernet Switches
Configuration Guide - IP Routing
Step 2 Run the interface vlanif vlan-id command to enter the VLANIF interface view.
Step 3 Run the ip binding vpn-instance vpn-instance-name command to bind the VPN instance to a
VLANIF interface.
By default, a VLANIF interface is not bound to any VPN instance.
Step 4 Run the ip address ip-address { mask | mask-length } command to assign an IP address to the
VLANIF interface.
----End

11.3.4 Checking the Configuration

Run the display ip vpn-instance [ verbose ] [ vpn-instance-name ] command to view
information about a VPN instance..
Run the display ip vpn-instance command. If the configuration is correct, you can view:
l
l
l
l
l
l
11.4 Configuring a Route Multi-Instance Between an MCE
and a Site
This section describes how to configure static routes, RIP, OSPF, IS-IS, and BGP between an
MCE and a site.
For configuring a route multi-instance between an MCE and a
Configuring a Static Route Between an MCE and a Site
BGP Between an MCE and a Site

11.4.1 Establishing the Configuration Task

Applicable Environment
To connect a CE to multiple VPNs and isolate services of these VPNs, you need to configure
MCE functions. Before configuring MCE functions, you need to perform the task of
Configuring a VPN Instance
between an MCE and a site.
Pre-configuration Tasks
Before configuring a route multi-instance between an MCE and a site, complete the following
task:
Issue 01 (2012-03-15)
NOTE
The ip binding vpn-instance command deletes Layer 3 features such as the IP address and routing
protocols configured on the interface. To use these features, you need to reconfigure them.
VPN instance created correctly
Name of the VPN instance
RD
Description
Maximum number of routes supported by the VPN instance
Interface configured correctly
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
are optional and can be configured as required.
on the MCE and PE and then configure a route multi-instance
11 MCE Configuration
site,11.4.2 (Optional)
to 11.4.6 (Optional) Configuring
11.3
632