Configuration Examples; Example For Configuring Basic Bgp4+ Functions - Huawei S6700 Series Configuration Manual

S6700 Series Ethernet Switches
Configuration Guide - IP Routing
Context
The BGP4+ statistics cannot be restored after being cleared. Exercise caution when running this
command.
Procedure
l
l
----End

8.15 Configuration Examples

This section provides several configuration examples of BGP4+.

8.15.1 Example for Configuring Basic BGP4+ Functions

Networking Requirements
As shown in
and Switch B, Switch C, and Switch D belong to AS 65009. BGP4+ is required to be used to
exchange routing information between the two ASs.
Figure 8-1 Networking diagram for configuring basic BGP4+ functions
VLANIF10
XGE0/0/1
Issue 01 (2012-03-15)
CAUTION
Run the reset bgp ipv6 dampening [ ipv6-address prefix-length ] command in the user
view to clear information about route dampening and release the suppressed routes.
Run the reset bgp ipv6 flap-info [ ipv6-address prefix-length | regexp as-path-regexp |
as-path-filter { as-path-filter-number | as-path-filter-name } ] command in the user view
to clear the statistics of route flapping.
Figure 8-1, there are two ASs: 65008 and 65009. Switch A belongs to AS 65008,
AS 65008
8::1/64
XGE0/0/2
VLANIF20
SwitchA
10::2/64
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
AS 65009
XGE0/0/2 XGE0/0/1
VLANIF40
VLANIF20
9:1::1/64
10::1/64
SwitchB
8 BGP4+ Configuration
SwitchC
XGE0/0/1
VLANIF40
9:1::2/64
SwitchD
542