Configuring The Ripng Preference; Configuring Additional Metrics Of An Interface - Huawei S6700 Series Configuration Manual

S6700 Series Ethernet Switches
Configuration Guide - IP Routing
Pre-configuration Tasks
Before configuring RIPng route attributes, complete the following tasks:
l
l
Data Preparation
To configure RIPng route attributes, you need the following data.
No.
1
2
3

3.4.2 Configuring the RIPng Preference

When there are routes discovered by multiple routing protocols on the same router, you can
make the router prefer RIPng routes by setting the RIPng preference.
Context
Each routing protocol has its preference, according to which a routing policy selects the optimal
route. The RIPng preference can be set manually. The greater the value is, the lower the
preference is.
Do as follows on the RIPng switch:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ripng [ process-id ]
The RIPng process is enabled and the RIPng view is displayed.
Step 3 Run:
preference { preference | route-policy route-policy-name } *
The RIPng preference is set.
----End

3.4.3 Configuring Additional Metrics of an Interface

You can set additional metrics for received and sent RIPng routes by using different commands.
Issue 01 (2012-03-15)
Configuring IPv6 addresses for interfaces to ensure that neighboring nodes are reachable
at the network layer
2.3 Configuring Basic RIP Functions
Data
Additional metric of the interface
RIPng preference
Maximum number of equal-cost routes
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 RIPng Configuration
64