Filtering Routes Advertised By Rip - Huawei S6700 Series Configuration Manual

S6700 Series Ethernet Switches
Configuration Guide - IP Routing
Pre-configuration Tasks
Before applying filters to advertised routes, complete the following tasks:
l
l
l
Data Preparation
To apply filters to advertised routes, you need the following data.
No.
1
2
3

10.6.2 Filtering Routes Advertised by RIP

By applying filters, you can control the advertisement of RIP routes.
Context
Do as follows on the switch that runs RIP:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
rip [ process-id ]
A RIP process is enabled and the RIP view is displayed.
Step 3 Run
filter-policy { acl-number | acl-name acl-name | ip-prefix ip-prefix-name } export
[ protocol [ process-id ] | interface-type interface-number ]
The filtering policy is configured for routes advertised by RIP.
Issue 01 (2012-03-15)
LSDB. The device, however, can advertise LSAs that carry the routing information
discovered by the specific routing protocol itself to other switches.
NOTE
l BGP has powerful filtering function. For details of BGP configuration, refer to .
l You can run the filter-policy command and the import-route command with different parameters for
RIP, OSPF, IS-IS, and BGP. For details, refer to related configurations.
10.3 Configuring the IP-Prefix List
Configuring an ACL
10.4 Configuring the Route-Policy
Data
Name of the IP prefix list
Name of the ACL
Name of the Route-Policy and node number
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
10 Routing Policy Configuration
607