Huawei S6700 Series Configuration Manual page 264
Ip routing
Hide thumbs
Also See for S6700 Series:
- Configuration manual (295 pages) ,
- Hardware description (115 pages) ,
- Hardware installation and maintenance manual (183 pages)
Table of Contents
Advertisement
S6700 Series Ethernet Switches
Configuration Guide - IP Routing
l
l
----End
Issue 01 (2012-03-15)
The system view is displayed.
2.
Run:
isis [ process-id ]
An IS-IS process is created, and the IS-IS process view is displayed.
3.
Run:
is-level { level-1 | level-1-2 | level-2 }
The level of the switch is configured.
(Optional) Configure IS-IS host name mapping.
1.
Run:
system-view
The system view is displayed.
2.
Run:
isis [ process-id ]
An IS-IS process is created, and the IS-IS process view is displayed.
3.
Run:
is-name symbolic-name
IS-IS dynamic host name mapping is configured. The system ID of the local device
is mapped to the specified host name.
The value of symbolic-name is contained in LSP packets and advertised to other IS-
IS devices.
On another IS-IS device displays the value of symbolic-name, but not the system ID,
of the local IS-IS device.
4.
Run:
is-name map system-id symbolic-name
IS-IS static host name mapping is configured. The system ID of a peer IS-IS device
is mapped to the specified host name.
This command configuration takes effect only on the local IS-IS device. The value of
symbolic-name will not be added to LSP packets.
If dynamic host name mappings is configured on an IS-IS network, the mappings on
the network overwrite the mappings configured on the local switch.
(Optional) Enable the output of the IS-IS adjacency status.
1.
Run:
system-view
The system view is displayed.
2.
Run:
isis [ process-id ]
An IS-IS process is created, and the IS-IS view is displayed.
3.
Run:
log-peer-change
The output of the adjacency status is enabled.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 IS-IS Configuration
245
Advertisement
Table of Contents
