Checking The Configuration - Huawei S6700 Series Configuration Manual

S6700 Series Ethernet Switches
Configuration Guide - IP Routing
Procedure
l
l
----End

10.5.6 Checking the Configuration

After filters are applied to the received routes, you can check information about the routing table
of each protocol.
Prerequisites
The configurations for applying filters to received routes are complete.
Procedure
l
Issue 01 (2012-03-15)
Filtering the Received Routes
Do as follows on the switch that runs BGP:
1. Run:
system-view
The system view is displayed.
2. Run:
bgp as-number
The BGP view is displayed.
3. Run:
filter-policy { acl-number | acl-name acl-name | ip-prefix ip-prefix-
name } import
The filtering policy is configured for routes received by BGP.
Filtering Routes Received from the Peers or Peer Groups
Do as follows on the switch that runs BGP:
1. Run:
system-view
The system view is displayed.
2. Run:
bgp as-number
The BGP view is displayed.
3. Run:
ipv4-family unicast
The IPv4 unicast address family view is displayed.
4. Run:
peer { group-name | ipv4-address } filter-policy { acl-number | acl-name
acl-name } import
The filtering policy is configured for routes received from peers or peer groups.
Run the display rip process-id route command to check information about the RIP routing
table.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
10 Routing Policy Configuration
605