Huawei S6700 Series Configuration Manual page 475

S6700 Series Ethernet Switches
Configuration Guide - IP Routing
SwitchC
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
Configuration Procedure
1.
2.
3.
4.
Issue 01 (2012-03-15)
XGE 0/0/2
Configure OSPF on SwitchB and SwitchC.
Create an EBGP peer relationship on SwitchA and SwitchB.
Configure BGP to interact with OSPF on SwitchB and check the routes.
Configure BGP route aggregation on SwitchB to simplify the BGP routing table.
The VLAN ID of each interface is shown in
The IP address of each VLANIF interface is shown in
The router ID of SwitchA is 1.1.1.1 and the number of the AS where it resides is 65008.
The router IDs of SwitchB and SwitchC are 2.2.2.2 and 3.3.3.3, and the number of the AS
where they reside is 65009.
Create a VLAN to which each interface belongs.
The configuration details are not mentioned here.
Assign an IP address to each VLANIF interface.
The configuration details are not mentioned here.
Configure OSPF.
# Configure SwitchB.
[SwitchB] ospf 1
[SwitchB-ospf-1] area 0
[SwitchB-ospf-1-area-0.0.0.0] network 9.1.1.0 0.0.0.255
[SwitchB-ospf-1-area-0.0.0.0] quit
[SwitchB-ospf-1] quit
# Configure SwitchC.
[SwitchC] ospf 1
[SwitchC-ospf-1] area 0
[SwitchC-ospf-1-area-0.0.0.0] network 9.1.1.0 0.0.0.255
[SwitchC-ospf-1-area-0.0.0.0] network 9.1.2.0 0.0.0.255
[SwitchC-ospf-1-area-0.0.0.0] quit
[SwitchC-ospf-1] quit
Create an EBGP peer relationship.
Configure SwitchA.
[SwitchA] bgp 65008
[SwitchA-bgp] router-id 1.1.1.1
[SwitchA-bgp] peer 3.1.1.1 as-number 65009
[SwitchA-bgp] ipv4-family unicast
[SwitchA-bgp-af-ipv4] network 8.1.1.0 255.255.255.0
[SwitchA-bgp-af-ipv4] quit
[SwitchA-bgp] quit
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
VLANIF 40
Figure 7-6.
Figure 7-6.
7 BGP Configuration
9.1.2.1/24
456