Setting The Cost Of The Ospfv3 Interface; Setting The Maximum Number Of Equal-Cost Routes - Huawei S6700 Series Configuration Manual

S6700 Series Ethernet Switches
Configuration Guide - IP Routing
l
l
Data Preparation
To configure OSPFv3 route attributes, you need the following data.
No.
1
2

5.7.2 Setting the Cost of the OSPFv3 Interface

OSPFv3 can automatically calculate the link cost for an interface according to the interface
bandwidth. You can also set the link cost for the interface by using the related command.
Context
You can control route calculation by setting the link cost of OSPFv3 on different interfaces.
Do as follows on the switch that runs OSPFv3.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface vlanif interface-number
The interface view is displayed.
Step 3 Run:
ospfv3 cost cost [ instance instance-id ]
The cost is set on the OSPFv3 interface.
By default, the link cost on an OSPFv3 interface is 1.
----End

5.7.3 Setting the Maximum Number of Equal-Cost Routes

If the destinations and costs of the multiple routes discovered by one routing protocol are the
same, load balancing can be performed among these routes.
Context
Do as follows on the switch that runs OSPFv3:
Issue 01 (2012-03-15)
Enabling IPv6 capability
Configuring Basic OSPFv3 Functions
Data
Link cost
Maximum number of equal-cost routes
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 OSPFv3 Configuration
200