Huawei S6700 Series Configuration Manual page 390
Ip routing
Hide thumbs
Also See for S6700 Series:
- Configuration manual (295 pages) ,
- Hardware description (115 pages) ,
- Hardware installation and maintenance manual (183 pages)
Table of Contents
Advertisement
S6700 Series Ethernet Switches
Configuration Guide - IP Routing
l
Issue 01 (2012-03-15)
– IP address of a loopback interface on a reachable peer
– IP address of a sub-interface on a directly-connected peer
4.
Run:
peer ipv4-address connect-interface interface-type interface-number
[ ipv4-source-address ]
The source interface and source address are specified for establishing a TCP
connection.
By default, BGP uses the physical interface that is directly connected to the peer as
the local interface of a TCP connection.
NOTE
When loopback interfaces are used to establish a BGP connection, run the peer connect-
interface command at both ends of the connection to ensure that the connection is correctly
established. If this command is run on only one end, the BGP connection may fail to be
established.
5.
(Optional) Run:
peer ipv4-address description description-text
A description is configured for the peer.
Configuring a description for a peer simplifies network management.
Configure an EBGP peer.
1.
Run:
system-view
The system view is displayed.
2.
Run:
bgp as-number
The BGP view is displayed.
3.
Run:
peer ipv4-address as-number as-number
The IP address of a peer and the number of the AS where the peer resides are specified.
The number of the AS where the specified peer resides must be different from that of
the local AS.
The IP address of the specified peer can be one of the following types:
– IP address of an interface on a directly-connected peer
– IP address of a loopback interface on a reachable peer
– IP address of a sub-interface on a directly-connected peer
4.
(Optional) Run:
peer ipv4-address connect-interface interface-type interface-number
[ ipv4-source-address ]
The source interface and source address are specified for establishing a TCP
connection.
By default, BGP uses the physical interface that is directly connected to the peer as
the local interface of a TCP connection.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 BGP Configuration
371
Advertisement
Table of Contents
