Huawei S6700 Series Configuration Manual page 501

S6700 Series Ethernet Switches
Configuration Guide - IP Routing
Figure 7-11 Networking diagram for configuring BFD for BGP
switch
SwitchA
SwitchA
SwitchB
SwitchB
SwitchB
SwitchC
SwitchC
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
Issue 01 (2012-03-15)
XGE0/0/2
EBGP
XGE0/0/1
SwitchA
AS 100
EBGP
Interface
XGigabitEthernet0/0/1
XGigabitEthernet0/0/2
XGigabitEthernet0/0/1
XGigabitEthernet0/0/2
XGigabitEthernet0/0/3
XGigabitEthernet0/0/1
XGigabitEthernet0/0/2
Configure basic BGP functions on each switch.
Configure MED attributes to control the route selection.
Enable BFD on Switch A and Switch B.
Router IDs and AS numbers of Switch A Switch B, and Switch C
Peer IP address detected by BFD
Minimum interval for sending BFD control packets, minimum interval for receiving BFD
control packets, and local detection multiplier
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
SwitchB
XGE0/0/3
XGE0/0/2
XGE0/0/1
IBGP
AS 200
XGE0/0/2
XGE0/0/1
SwitchC
7 BGP Configuration
VLANIF interface IP address
VLANIF 10 200.1.2.1/24
VLANIF 20 200.1.1.1/24
VLANIF 30 9.1.1.1/24
VLANIF 20 200.1.1.2/24
VLANIF 40 172.16.1.1/24
VLANIF 10 200.1.2.2/24
VLANIF 30 9.1.1.2/24
482