Configuring An Ipv6 Static Route; Establishing The Configuration Task; Configuring An Ipv6 Static Route On The Public Network - Huawei S6700 Series Configuration Manual

S6700 Series Ethernet Switches
Configuration Guide - IP Routing

1.4 Configuring an IPv6 Static Route

On an IPv6 network, you can accurately control route selection by configuring IPv6 static routes.

1.4.1 Establishing the Configuration Task

Before configuring an IPv6 static route, familiarize yourself with the applicable environment,
complete the pre-configuration tasks, and obtain the data required for the configuration. This
will help you complete the configuration task quickly and accurately.
Applicable Environment
On a small IPv6 network, you can implement network interconnection by configuring IPv6 static
routes. Compared with using dynamic routes, using static routes saves the bandwidth.
Pre-configuration Tasks
Before configuring an IPv6 static route, complete the following task:
l
Data Preparation
To configure an IPv6 static route, you need the following data.
No.
1
2
3

1.4.2 Configuring an IPv6 Static Route on the Public Network

When configuring an IPv6 static route, you need to correctly configure its destination address,
outbound interface, and next hop.
Context
Do as follows on the switch to be configured with static routes:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Issue 01 (2012-03-15)
Configuring link layer protocol parameters and IP addresses for interfaces to ensure that
the link layer protocol status of the interfaces is Up
Data
Destination address and mask
Outbound interface or next-hop IPv6 address
Preference of the IPv6 static route
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 IP Static Route Configuration
6