Configuring An Overload Bit For An Ipv6 Is-Is Device - Huawei S6700 Series Configuration Manual

S6700 Series Ethernet Switches
Configuration Guide - IP Routing
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
isis [ process-id ]
The IS-IS view is displayed.
Step 3 Run:
ipv6 filter-policy { acl6-number | acl6-name acl6-name | ipv6-prefix ipv6-prefix-
name | route-policy route-policy-name } import
Conditions for filtering IS-IS routes are configured.
----End

6.12.5 Configuring an Overload Bit for an IPv6 IS-IS Device

If an IS-IS device needs to be temporarily isolated, configure the IS-IS device to enter the
overload state to prevent other devices from forwarding traffic to this IS-IS device and prevent
blackhole routes.
Context
If an IS (for example, an IS to be upgraded or maintained) needs to be temporarily isolated,
configure the IS to enter the overload state so that no device will forward traffic to this IS.
IS-IS routes converge more quickly than BGP routes. To prevent blackhole routes on a network
where both IS-IS and BGP are configured, set an overload bit to instruct an IS to enter the
overload state during its start or restart. After BGP convergence is complete, cancel the overload
bit.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
isis [ process-id ]
The IS-IS view is displayed.
Step 3 Run:
set-overload [ on-startup [ timeout1 | start-from-nbr system-id [ timeout1
[ timeout2 ] ] | wait-for-bgp [ timeout1 ] ] ] [ allow { interlevel | external }
*
]
The overload bit is configured.
----End
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 IS-IS Configuration
298