Checking The Configuration - Huawei S6700 Series Configuration Manual

S6700 Series Ethernet Switches
Configuration Guide - IP Routing
Do as follows on the RIP switch:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
The interface must be a VLANIF interface.
Step 3 Run the following command as required:
l Run:
l Run:
----End

2.7.4 Checking the Configuration

After RIP-2 features are successfully configured, you can view the current running status,
configuration, and routing information of RIP.
Prerequisites
The configurations of RIP-2 features are complete.
Procedure
l
l
l
----End
Issue 01 (2012-03-15)
rip authentication-mode simple password
Simple authentication in the plain text is configured for RIP-2 packets.
rip authentication-mode md5 { nonstandard { password-key1 key-id } | usual
password-key2 }
MD5 authentication in the cipher text is configured for RIP-2 packets.
NOTE
The MD5 type must be specified if MD5 authentication is configured. The usual type supports private
standard authentication packets, and the nonstandard type supports IETF standard authentication packets.
The MD5 authentication password that starts and ends with $@$@ is invalid, because $@$@ is used to
distinguish old and new passwords.
Run the display rip [ process-id | vpn-instance vpn-instance-name ] command to check
the running status and configuration of RIP.
Run the display rip process-id database [ verbose ] command to check all activated RIP
routes in the database.
Run the display rip process-id route command to check all the RIP routes that are learned
from other switchs.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 RIP Configuration
42