Example For Configuring Rip To Import Routes - Huawei S6700 Series Configuration Manual

S6700 Series Ethernet Switches
Configuration Guide - IP Routing
l

2.10.2 Example for Configuring RIP to Import Routes

Networking Requirements
As shown in
exchanges routing information with Switch A through RIP100 and exchanges routing
information with Switch C through RIP200.
You must configure route import on Switch B so that the two RIP processes can import RIP
routes of each other. By default, the metric of the imported routes of RIP200 is set to 3. In
addition, you must configure a filtering policy on Switch B. Thus, Switch B can filter out a route
imported from RIP200 (route to 192.168.4.0/24) and does not advertise the route to Switch A.
Figure 2-2 Networking diagram for configuring RIP to import external route
SwitchA
switch
Switch A
Issue 01 (2012-03-15)
vlan batch 20
#
interface Vlanif20
ip address 172.16.1.2 255.255.255.0
#
interface XGigabitEthernet0/0/2
port hybrid pvid vlan 20
port hybrid untagged vlan 20
#
rip 1
version 2
network 172.16.0.0
#
return
Configuration file of Switch D
#
sysname SwitchD
#
vlan batch 30
#
interface Vlanif30
ip address 10.1.1.2 255.255.255.0
#
interface XGigabitEthernet0/0/3
port hybrid pvid vlan 30
port hybrid untagged vlan 30
#
rip 1
version 2
network 10.0.0.0
#
return
Figure 2-2, two RIP processes, RIP100 and RIP200, run on Switch B. Switch B
XGE0/0/2
XGE0/0/1
XGE0/0/1
RIP
100
Interface
XGigabitEthernet0/0/1
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
XGE0/0/2
XGE0/0/2
SwitchB
RIP
200
2 RIP Configuration
XGE0/0/1
XGE0/0/3
SwitchC
VLANIF interface IP address
VLANIF 10 192.168.1.1/24
53