Configuring Basic Ipv6 Is-Is Functions; Establishing The Configuration Task - Huawei S6700 Series Configuration Manual

S6700 Series Ethernet Switches
Configuration Guide - IP Routing
Checking the Configuration
After BFD is enabled on both ends of a link, run the display isis [ process-id | vpn-instance
vpn-instance-name ] bfd session { all | peer ip-address | interface interface-type interface-
number } command.

6.11 Configuring Basic IPv6 IS-IS Functions

This section describes the procedures for configuring basic IPv6 IS-IS functions, including the
procedures for configuring IS-IS processes and interfaces, to implement communication
between nodes on an IPv6 IS-IS network.

6.11.1 Establishing the Configuration Task

Before configuring basic IPv6 IS-IS functions, familiarize yourself with the applicable
environment, complete the pre-configuration tasks, and obtain the required data.
Applicable Environment
To deploy IS-IS on an IPv6 network, configure basic IS-IS functions to implement
communication between different nodes on the network.
Other IS-IS functions can be configured only after basic IS-IS functions are configured.
Configuring basic IPv6 IS-IS functions includes the following operations:
1.
2.
Pre-configuration Tasks
Before configuring basic IPv6 IS-IS functions, complete the following tasks:
l
l
l
Data Preparation
To configure basic IPv6 IS-IS functions, you need the following data.
No.
1
2
3
Issue 01 (2012-03-15)
Create IPv6 IS-IS processes.
Configure IPv6 IS-IS interfaces.
Configure a link layer protocol.
Assign an IPv6 address to each interface to ensure IP connectivity.
Enable the IPv6 in system view.
Data
IS-IS process ID
NTE of an IS-IS process
Level of each device and level of each interface
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 IS-IS Configuration
284