Configuration Examples; Example For Configuring Basic Mbgp Functions - Huawei S6700 Series Configuration Manual

S6700 Series Ethernet Switches
Configuration Guide - IP Routing
When an MBGP fault occurs, run the following debugging commands in the user view to debug
MBGP and locate the fault.
For more information about debugging commands, refer to the S6700 Series Ethernet Switches
Debugging Reference.
Procedure
l
l
l
l
----End

9.9 Configuration Examples

MBGP configuration examples are provided, including networking requirements and diagram,
configuration roadmap, and configuration notes.

9.9.1 Example for Configuring Basic MBGP Functions

Networking Requirements
As shown in
and the source reside in different ASs. The MBGP peer relationship is established between ASs
to transmit multicast routing information.
Issue 01 (2012-03-15)
Run the debugging bgp all command in the user view to enable all the debugging of MBGP.
Run the debugging bgp event command in the user view to enable the debugging of MBGP
event.
Run the debugging bgp { keepalive | open | packet | route-refresh } [ receive | send ]
[ verbose ] command in the user view to enable the debugging of MBGP packets.
Run the debugging bgp update multicast [ acl acl-number | ip-prefix ip-prefix-name |
peer peer-address ] [ receive | send ] [ verbose ] command in the user view to enable the
debugging of MBGP update packets.
Figure 9-1, the receiver receives VOD information in multicast mode. The receiver
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 MBGP Configuration
582