Huawei S6700 Series Configuration Manual page 353

Hide thumbs Also See for S6700 Series:

Table of Contents

S6700 Series Ethernet Switches

Configuration Guide - IP Routing

Configuration Roadmap

The configuration roadmap is as follows:

Data Preparation

To complete the configuration, you need the following data:

Configuration Procedure

Issue 01 (2012-03-15)

Enable basic IS-IS functions on each Switch so that the Switches can be interconnected.

Set the number of equal-cost routes to 1 to carry out load balancing, and check information

about the routing table.

Configure load balancing on SwitchA and check information about the routing table.

(Optional) Configure the preference for equal-cost routes on SwitchA.

VLAN ID of each interface, as shown in

IP address of each VLANIF interface, as shown in

System ID, level, and area ID of each Switch

– Switch A: The system ID is 0000.0000.0001; the area ID is 10; the level is Level-2.

– Switch B: The system ID is 0000.0000.0002; the area ID is 10; the level is Level-2.

– Switch C: The system ID is 0000.0000.0003; the area ID is 10; the level is Level-2.

– Switch D: The system ID is 0000.0000.0004; the area ID is 10; the level is Level-2.

Number of equal-cost routes for load balancing on Switch A: 1

Load balancing mode on Switch A

Weight for the preference of the equal-cost routes on Switch C: 1

Configure the IDs of the VLANs to which the interfaces belong.

The configuration details are not mentioned here.

Assign IP addresses to VLANIF interfaces.

Huawei Proprietary and Confidential

6 IS-IS Configuration

172.16.1.1/24

192.168.0.1/24

10.1.2.2./24

192.168.1.1/24

192.168.0.2/24

192.168.1.2/24

172.17.1.1/24