Ipv6 Static Routing Configuration; Introduction To Ipv6 Static Routing; Features Of Ipv6 Static Routes; Default Ipv6 Route - H3C S5120-HI Series Configuration Manual

Layer 3, ip routing configuration
Hide thumbs Also See for S5120-HI Series:
Table of Contents

Advertisement

IPv6 static routing configuration

Introduction to IPv6 static routing

Static routes are manually configured. They work well in simple networks. Proper configuration and use
can improve network performance and ensure enough bandwidth for important applications.
However, static routes also have limitations. Any topology changes require manual configuration and
modification to the relevant static routes.

Features of IPv6 static routes

Similar to IPv4 static routes, IPv6 static routes work well in simple IPv6 network environments.
Their major difference lies in the destination and next hop addresses. IPv6 static routes use IPv6
addresses, whereas IPv4 static routes use IPv4 addresses.

Default IPv6 route

An IPv6 static route with a destination prefix of ::/0 is a default IPv6 route. The default route is used to
forward packets that match no specific routes in the routing table.

Configuring an IPv6 static route

In small IPv6 networks, IPv6 static routes can be used to forward packets. In comparison to dynamic
routes, it helps to save network bandwidth.

Configuration prerequisites

Before configuring an IPv6 static route, complete the following tasks:
Configure parameters for the related interfaces
Configure link layer attributes for the related interfaces
Enable IPv6 packet forwarding
Ensure the neighboring nodes can reach each other

Configuration procedure

Follow these steps to configure an IPv6 static route:
To do...
Enter system view
Use the commands...
system-view
9
Remarks

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the S5120-HI Series and is the answer not in the manual?

Table of Contents