Power Module - Permobil M1 Service Manual

Repairs
3. Attach the R-net bus cabling in the cable clip on the underside of
the seat frame.
4. Attach the R-net bus cabling in the cable clips on the seat frame.
Make sure that the middle part of the cable goes under the lip on the
seat tilt.
5. Attach the two cable ties according to the picture. If there is a
power leg rest on the wheelchair; the actuator cabling must be tied
together with the control panel cabling.
6. Attach the R-net bus cabling in the cable clip on the seat post.
7. Connect the R-net bus cable into the ESP or the ISM, see
ISM and ESP , Page 61.
1. Switch On the main power switch on the control panel.
2. Switch the main circuit breaker to On. See
Main circuit breaker , Page 79.
3. Mount back the chassis covers, see Covers , Page 14.

Power module

For this task the following tools are necessary:
• Torque wrench
• Ring wrench, 8 mm.
76
Figure 231. The position of the cable clip on the
underside of the seat frame.
Figure 232. The position of the cable clips on the seat
frame.
Figure 233. The position of the cable ties and cable
clip between the seat and chassis.
Figure 234. On/Off symbol depending on model.
Permobil M1