Permobil M1 Service Manual page 122

Adjustments
Adjusting length
1. Open the snap-lock cover on both sides.
2. Pull the belt ends to required length.
3. Check that the belt buckle (C) is in the center position. See
Figure 363.
4. Close the snap-lock cover. The two lugs on the plastic cover must
snap into the metal bracket recess.
5. Pull the strap to check that the snap-lock cover is in the locked
position.
Belt lock components
A. D-ring.
B. Belt strap.
C. Buckle.
D. Release button.
E. Latch plate.
To tighten the positioning belt
1. Insert the latch plate (E) into the buckle (C). Check that it locks
properly in the snap lock.
2. Pull the belt strap using the attached D-ring (A) until the belt is
tightened.
To release positioning belt tension
1. Press the release button (D) on the buckle to release the latch plate
(E).
2. Hold the buckle (C) in an 90° angle to the belt and pull to desired
length.
3. Insert the latch plate (E) into the buckle (C). Check that it locks
properly in the snap lock.
4. Pull the D-ring (A) until the belt is tightened.
WARNING!
Use installed positioning aids
The user must use and securely fasten the positioning belt and any other
positioning aids on the wheelchair. Failure to properly use positioning belts
and other positioning aids may cause bodily injury. If there is any sign of
damage or wear on any positioning belt or aids, immediately contact
Permobil for a replacement.
122
Figure 361. The snap-lock cover of the Cinch–Mount™.
Figure 362. Belt lock components.
Figure 363. D-ring (A) and buckle (C).
Permobil M1