Permobil M1
26. Tilt the seat backwards and adjust the length of the leg rest actuator
cable.
If necessary, adjust the manual backrest adjustment unit to correct set
the backrest angle.
1. Secure the backrest by holding it in place before loosen either of the
bolts, A and B.
2. Loosen the two bolts A and B indicated by the arrows.
3. Adjust the backrest to required angle.
4. Secure the lever by tightening bolts. Tightening torque 7.2 ft lb.
5. Check that the backrest is locked in position.
6. Mount seat plates of a suitable length for the seat depth setting. The
plates are held in place by two bolts each (A, B). See
Install seat plates .
Bodypoint® positioning belt
Accessory
This section describes the Bodypoint® 2-point positioning belt. It is
attached to the UniTrack rail with a Cinch–Mount™ on each side of
the seat.
Figure 358. Leg rest actuator cable.
Figure 359. Manually adjusting the backrest angle.
Figure 360. The seat plates are held in place by two
bolts each.
Adjustments
121