Permobil M1 Service Manual page 55

Permobil M1
5. Remove the cable from the cable tunnel (A).
6. Remove the bracket holding the cable. Fitted with one screw (B).
Leave the cable clip on so that the clip is maintained at correct place
on the cable.
7. Unscrew the screw (B) to the cable clip (A) and remove the cable.
8. Remove the drive unit (F) and the bracket (E). It is fitted with four
screws (C) and two washers (D).
Mounting drive unit
1. Mount the drive unit (F) and bracket (E) to the front swing arm
using the four screws (C) and two washers (D). Tighten the screw
using a torque wrench. Tightening torque: 7,2 lb.ft.
2. Attach the cable to the cable clip (A) and fasten it to the bracket (E)
with screw (B).
3. Position the clip by the marking on the cable.
A
B
Figure 150. Remove the cables before disassembling
the drive unit.
Figure 151. Drive unit removal.
Figure 152. Drive unit assembly.
E
Figure 153. Attach cable and cable clip to bracket.
Repairs
B
A
55