Permobil M1 Service Manual page 21

Permobil M1
Removing drive unit covers
1. Switch off the main power switch on the control panel.
2. Remove the fender. See page 18
3. Remove the brake release cover, it is attached with one screw.
4. Remove the drive unit cover, it is attached with two screws.
5. On wheelchairs equipped with turn signals, disconnect the turn
signal's cabling from the rear of the turn signals.
Mounting drive unit covers
1. Switch off the main power switch on the control panel.
2. On wheelchairs equipped with turn signals, connect the turn signal's
cabling into the rear of the turn signals.
3. Mount the drive unit cover with the two screws. Tightening
torque: 0.9 lb.ft.
Figure 34. On/Off symbol depending on model.
Figure 35. Brake release cover.
Figure 36. Drive unit cover.
Figure 37. On/Off symbol depending on model.
Figure 38. Drive unit cover.
Repairs
21