Permobil M1 Service Manual page 20

Repairs
2. Mount the fenders onto the chassis.
3. Assemble the two knobs holding the fenders without tightening
them.
4. Tighten the screw in the countersink hole in the front of the fender.
Tightening torque: 2.1 lb.ft.
5. Attach the accent cover. Start with inner snap hook and pinch the
accent cover to mount the middle snap hook next. And then the
outer snap hook will go in its position automatically.
6. Manually tighten the two knobs holding the fenders.
20
Figure 30. Place the fender on the drive unit.
Figure 31. The fenders are fitted with two knobs.
Figure 32. The positioning of the screw.
Figure 33. Accent cover.
Permobil M1