Permobil M1 Service Manual page 39

Permobil M1
5. Remove the three screws that hold the wheel in place. The central
screw must not be removed.
6. Remove the three washers.
7. Remove the wheel by pulling it straight out.
8. Remove the spacer.
Installing drive wheels
1. Fit the spacer. There is a lip on the spacer to hold it in place. Face
the lip towards the chair.
2. Fit the wheel onto the wheel hub.
3. Insert the three screws and the three washers. Tighten the screws no
more than 11 lb.ft.
4. When all screws and washers are in place, tighten the screws.
Tightening torque 17.7 lb.ft.
5. Push the hub cap in place. On pneumatic wheels, the air valve must
be aligned with the slot in the hub cap.
6. Remove the blocks.
7. Lower the wheelchair using a jack or equivalent.
Figure 100. Pull the wheel straight out after you have
removed the three screws.
Figure 101. Fit the wheel onto the wheel hub.
Figure 102. Face the lip on the spacer towards the
chair.
Figure 103. The hub cap snaps when it is in place.
Repairs
39