Permobil M1 Service Manual page 16

Repairs
6. Pull the front cover off the chassis. Note that the cover is mounted
with snap hooks on the lower part of the chassis.
Mounting chassis covers
1. Use the control panel and tilt the seat to get access to cables and
screws. If the seat is fixed use the service mode position to lift the
seat. See page 111.
2. Use the control panel to raise the leg rest. For manual leg rest, pull
out the handle to raise the leg rest.
3. Switch off the main power switch on the control panel.
4. Mount the rear cover onto the chassis by positioning the cover on
the swing arms axles.
5. Secure the cover by pressing its upper part against the Velcro tape
strip on the back of the chassis.
16
Figure 13. The snap hooks are mounted in the lower
part of the chassis.
Figure 14. On/Off symbol depending on model.
Figure 15. The rear cover.
Figure 16. An enlargement of the rear cover going over
the rear swing arm axle.
Permobil M1