Permobil M1 Service Manual page 70

Repairs
5. Attach the control panel cabling in the cable clip on the underside of
the seat frame.
6. Attach the control panel cabling in the cable clips on the seat frame.
Make sure that the middle part of the cable goes under the lip on the
seat tilt.
7. Attach the two cable ties according to the picture. If there is a
power leg rest on the wheelchair; the actuator cabling must be tied
together with the control panel cabling.
8. Attach the control panel cabling in the cable clip on the seat post.
9. Attach the two cable ties according to the picture. The top cable ties
goes through a hole on the seat post base.
70
Figure 207. The position of the cable clip on the
underside of the seat frame.
Figure 208. The position of the cable clips on the seat
frame.
Figure 209. The position of the cable ties and cable
clip between the seat and chassis.
Figure 210. The position of the cable ties at the base of
the seat post.
Permobil M1