Permobil M1 Service Manual page 57

Permobil M1
3. Jack up the wheelchair.
4. Remove the chassis covers, the fenders and the drive unit cover. See
Covers , Page 14.
5. Remove the drive wheels. See Drive wheels , Page 37
.
6. Disconnect the drive unit cable from the power module.
7. Disconnect the magnetic wheel lock cable at the connector by the
power module.
8. Remove the cable from the cable cover (A).
9. Remove the two cable ties that holds the cable (B).
10. Loosen the screws holding the two cable clips and remove the cable
(C).
11. Spin the cable cover off the cables.
12. Remove the cable tie located at the base of the motor.
Figure 157. The connectors of the magnetic wheel
locks.
Figure 158. Remove cable from its attachments.
Figure 159. Cable cover.
Figure 160. The cable tie is located at the base of the
motor.
Repairs
57