Repairs
5. Remove the control panel cabling from the cable clips on the inside
of the armrest arm.
6. Disconnect the control panel cabling from the R-net bus cable
connection.
7. Remove the control panel. It is held in place by two screws.
Mounting R–net control panel
1. Assemble the control panel. It is held in place by two screws.
Tightening torque: 2.2 lb.ft.
72
Figure 215. The position of the cable clips on the inside
of the armrest arm.
Figure 216. The position of the connector.
Figure 217. The control panel with the parallel panel
holder is held in place by two screws on the parallel
panel holder.
Figure 218. The control panel with the parallel panel
holder is held in place by two screws on the parallel
panel holder.
Permobil M1