Permobil M1 Service Manual page 113

Permobil M1
• Allen socket, 3 mm.
• Allen socket, 4 mm.
• Socket, 10 mm
• Means of documentation (camera, pen and paper etc.).
If only the lower part are going to be replaced, remove the seat, see
page 82
If both upper and lower part are being replaced, follow the instructions
above. See Remove upper part of fixed seat , page 111.
8. Loosen the two screws that are mounted by the key holes (A).
9. Remove other six screws.
10. Lift of the lower part of the seat tilt from the chassis.
Install seat tilt, lower part
The following tools are necessary for this task:
• Torque wrench.
• Allen socket, 3 mm.
• Allen socket, 4 mm.
• Socket, 10 mm
• Means of documentation (camera, pen and paper etc.).
1. Hang the lower part of the fixed seat tube, using the keyholes, on to
the two screws on the chassis.
2. Attach the other six screws to the seat. Allen socket 6 mm.
Tightening torque: 17,7 lb.ft.
3. Tighten the two screws by the key holes (A). Allen socket 6 mm.
Tightening torque: 17,7 lb.ft.
1. Attach the seat, see page 82, or attach the upper part of the seat tilt,
see page 112.
Cushions
Cushion insert puncture repair
For repairs to the cushions, see the instructions provided with the
cushion and/or the cushion repair kit.
Figure 341. Removing the lower part of the seat tilt.
Figure 342. Attach eight screws to the seat.
Repairs
113