Permobil M1 Service Manual page 108

Repairs
5. Put seat frame and backrest on the upper part of the seat tilt and
attach four screws.
6. Connect cables. Do a check of your recorded cable installation.
7. Attach the covers. See Mounting chassis covers , Page 16
8. Attach the seat plates. See Install seat plates , Page 96
9. Attach the seat cushion by pushing it against the seat plate. Make
sure that the Velcro tape on the bottom side of the cushion is
attached to the seat.
Seat tilt, lower part
Remove seat tilt, lower part
1. Remove the seat. See Remove seat , Page 81.
2. Remove ISM (Intelligent seating module) (A) if installed.
3. Remove ESP (Enhanced steering performance) (B) if installed.
4. Remove two screws to the plate that holds electronics.
108
Figure 327.
A
Figure 328. Remove ISM (intelligent seating module) (A)
and ESP (Enhanced steering performance) (B) if installed.
Figure 329. Remove two screws to the plate that holds
electronics.
Permobil M1
B