Vr2 Control Panel - Permobil M1 Service Manual

Repairs
Mounting the ISM/ESP holder
1. Attach the two screws securing the holder. Tightening torque:
4.2 lb.ft.
2. Install the ISM (Intelligent Seating Module), see
Installing ISM , Page 62.
3. Remove the ESP (Enhanced Steering Performance), see
Installing ESP , Page 64.
4. Attach the cables into the cable holder, see .
5. Switch On the main power switch on the control panel.
6. Switch the main circuit breaker to On. See
Main circuit breaker , Page 79.
7. Mount back the front cover and the top cover, see
Removing chassis covers , Page 14.

VR2 control panel

The following tools are necessary for this task:
• 1 Allen key 4 mm.
Removing VR2 control panel
1. Switch Off the main power switch on the control panel.
2. Switch the main circuit breaker to Off. See
Main circuit breaker , Page 79.
3. Remove the chassis covers, see Covers , Page 14.
4. Remove the control panel cabling from the cable clips running
through the armrest pad.
66
Figure 191. The screws securing the holder to the seat
post.
Figure 192. On/Off symbol depending on model.
Figure 193. On/Off symbol depending on model.
Figure 194. The position of the cable clips under the
armrest pad.
Permobil M1