Permobil M1 Service Manual page 73

Permobil M1
2. Attach the control panel cabling in the cable clips running through
the armrest pad.
3. Attach the control panel cabling in the cable clips on the inside of
the armrest arm.
4. Connect the control panel cabling in the R-net bus cable
connection.
1. Switch On the main power switch on the control panel.
2. Switch the main circuit breaker to On. See
Main circuit breaker , Page 79.
3. Mount back the chassis covers, see Covers , Page 14.
Figure 219. The position of the cable clips under the
armrest pad.
Figure 220. The position of the cable clips on the inside
of the armrest arm.
Figure 221. The position of the connector.
Figure 222. On/Off symbol depending on model.
Repairs
73