Permobil M1 Service Manual page 68

Repairs
9. Remove the two cable ties.
10. Remove the control panel cabling from the cable clip on the seat
post.
11. Remove the two cable ties.
12. Remove the cable from the cable holders.
13. Disconnect control panel cable connector from the JSM connection
on the power module.
14. Remove the control panel. It is held in place by two screws.
68
Figure 199. The position of the cable ties and cable
clip between the seat and chassis.
Figure 200. The position of the cable ties at the base of
the seat post.
Figure 201. The position of the cable running in the
cable holders on the battery box.
Figure 202. The control panel with the standard panel
holder is held in place by two screws and two washers
on the panel holder.
Permobil M1