Permobil M1 Service Manual page 62

Repairs
Removing ISM
1. Document the cable setup into the ISM. The cable setup can vary
between different configurations.
2. Disconnect all cables connected to the ISM.
3. Lift the ISM out of the holder.
Installing ISM
1. Push down the new ISM into the holder. Note the direction of the
ISM; the contact interface must face inwards and the two R-net
contacts should be at the top.
62
Figure 175. It is important that you document the cable
setup. Take a photograph or draw it.
Figure 176. There could be different cables connected
to the ISM.
Figure 177. Lift it straight up.
Figure 178. Push it straight down.
Permobil M1