Permobil M1 Service Manual page 59

Permobil M1
4. Route the cables tight to the outside of the motor and attach them
in the cable clip on top of the motor (C). Use a torque wrench to
tighten the screw. Tightening torque: 0.88 lb.ft.
5. Attach the cables in the second cable clip (C). Tightening torque:
0.88 lb.ft. Position the cable clip over the white marking on the
motor cable.
6. Attach the cables in the bracket on the chassis box using two cable
ties (B), place the cable tie heads on the outside of the bracket.
7. Fit the cables into the cable cover on the chassis (A).
8. Fit the cable collector around the cables in the transition between
second cable clip and bracket.
9. Connect the magnetic wheel lock cable to the drive unit cable by
the power module.
10. Connect the drive unit cable to the power module.
11. Mount the covers, see Covers , Page 14.
12. Mount the drive wheel see Drive wheels , Page 37.
Wheel hubs
The following tools are necessary for this task:
• Torque wrench.
• Allen socket,6 mm.
Figure 165. Cable and cable clip placement.
Figure 166. Cabling magnetic wheel lock.
Figure 167. Cable cover.
Figure 168. The contacts of the magnetic wheel locks.
Repairs
59