Leg Rest - Permobil M1 Service Manual

Permobil M1
3. Put the seat extensions in position on both sides of the seat frame.
See Seat matrix, page 118 for correct seat depth setting.
The seat extensions are attached with the same screws as the
UniTrack rails.
4. Attach the UniTrack rails on both sides of the seat frame. See
Remove UniTrack rail
5. Install the backrest. See Installing backrest , Page 86.
6. Attach the seat plates. See page 96.
7. Attach the seat cushion by pushing it against the seat plate. Make
sure that the Velcro tape on the bottom side of the cushion is
attached to the seat.

Leg rest

Power leg rest
The following tools are necessary for this task:
• Torque wrench.
• Allen socket, 5 mm.
• Allen socket, 6 mm.
• Socket, 10 mm.
• Means of documentation (camera, pen and paper etc.).
Remove leg rest
WARNING!
Risk of injury while adjusting leg rest
Do not place any weight or load on the leg rest while adjusting the leg rest.
1. Remove the seat cushion by lifting it straight up. It is attached with
Velcro tape on the bottom side of the cushion.
2. Remove the seat plates. See Remove seat plates , Page 96
Figure 304. Fit the seat extensions.
Repairs
99