Permobil M1 Service Manual page 78

Repairs
Mounting R-net power module
1. Mount the power module, it is fitted with two nuts. Tightening
torque: 2.1 lb.ft.
2. Mount back the main circuit breaker, see
Main circuit breaker , Page 79.
3. Check the documentation of the connections.
4. Reconnect the connections to the R-net controller and push the
cables into the cable holders.
5. Reassemble the chassis covers, see Covers , Page 14.
6. Switch the main circuit breaker to On. See
Main circuit breaker , Page 79.
(A) BUS
M1
Motor 1, Left
(B) Battery
M2
Motor 2, Right
INH-2
Inhibit
OBC
External charger socket
A1
Seat tilt
A2 Leg rest
Mounting VR2 power module
1. Mount the power module, it is fitted with two nuts. Tightening
torque: 2.1 lb.ft.
2. Mount back the main circuit breaker, see
Main circuit breaker , Page 79.
78
Figure 239. The nuts securing the power module.
Figure 240. Power module cable connections (R-net
PM90).
Figure 241. The nuts securing the power module.
Permobil M1