Permobil M1 Service Manual page 136

Adjustments
5. Turn the adjustment links to desired position.
6. Refit the two plates.
7. Refit the two screws securing the plates. Tightening torque: 7.2 lb.ft.
8. Mount the panel holder, see .
9. Mount the panel; see .
Panel holder base position
1. Remove the panel holder; see .
2. Remove the two screws securing the panel holder to bracket.
136
Figure 403. The adjustment links have teeth that mesh
with a corresponding set of teeth in the panel holder.
Figure 404. The two plates.
Figure 405. The two screws securing the plates.
Figure 406. The two screws with washers on the new
parallel panel holder.
Permobil M1