Permobil M1 Service Manual page 83

Permobil M1
5. Record the cable installation and pin position. The cable installation
can vary between different configurations.
6. Disconnect cables.
Secure the seat in horizontal position, either by using a traverse or
being two people during this work.
7. Lift off the seat.
Use a protection mat to prevent damage to the seat and surface.
Install seat
1. Put the seat on the lower part of the fixed seat.
2. Connect cables. Do a check of your recorded cable installation.
3. Attach the covers. See Mounting chassis covers , Page 16
4. Move screw from position (B) into position (A).
5. Tighten the screw, torque 84 lb.ft.
6. Attach the seat plates. See Install seat plates , Page 96.
7. Attach the seat cushion by pushing it against the seat plate. Make
sure that the Velcro tape on the bottom side of the cushion is
attached to the seat.
Figure 252. Record the cable installation. Take a
photography or draw it.
Figure 253. Lift off the seat.
Figure 254. Move screw from position (B) into position
(A) .
Repairs
83