Permobil M1 Service Manual page 124

Adjustments
Adjusting curved solid backrest height
1. Unscrew the two screws on each side (B) holding the backrest (C).
2. Adjust the height of the backrest (C).
3. Assemble the backrest (C) to the backrest frame (A). Fasten the
screws (B). Tightening torque:7.2lb.ft.
ROHO® AGILITY® backrest
Applicable for both ROHO® AGILITY® Agility Mid Contour and
ROHO® AGILITY® Agility Max Contour
The following tools are necessary for this tasks:
• Torque wrench.
• 1 Allen socket, 4 mm.
Adjusting ROHO® AGILITY® backrest height
1. Loosen but do not remove screws (A).
2. Slide holders up/down the backrest frame to desired position. Use a
measuring tape to ensure that both holders are at the same height.
3. Tighten screws (A). Tightening torque: 3.3 lb.ft
Adjusting ROHO® AGILITY® backrest angle
1. Loosen but do not remove screws (A) on each side.
2. Adjust backrest angle to desired position.
3. Tighten screws (A) on each side. Tightening torque: 5.2 lb.ft
124
Figure 366. Adjusting height of curved solid backrest.
Figure 367. Adjusting ROHO® AGILITY® backrest
height.
Figure 368. Adjusting ROHO® AGILITY® backrest
angle.
Permobil M1