Seat Tilt - Permobil M1 Service Manual

Repairs

Seat tilt

The following tools are necessary for this task:
• Torque wrench.
• Allen socket, 3 mm.
• Allen socket, 4 mm.
• Allen socket, 6 mm.
• Allen socket, 10 mm.
• Socket 10 mm
• Means of documentation (camera, pen and paper etc.).
Seat tilt, upper part
Remove seat tilt, upper part
1. Remove the seat cushion by lifting it straight up. It is attached with
Velcro tape on the bottom side of the cushion.
2. Remove the seat plates. See page 96.
3. Remove covers. See Removing chassis covers , Page 14.
4. Record the cable installation. The cable installation can vary
between different configurations.
5. Disconnect cables.
Secure the seat in horizontal position, either by using a traverse or
being two people during this work.
6. Remove seat frame and backrest by removing four screws.
7. Lift off the seat frame and the backrest.
Use a protection mat to prevent damage to the seat and surface.
8. Remove leg rest. See Remove leg rest , Page 99.
106
Figure 322. Record the cable installation. Take a
photography or draw it.
Figure 323. Remove seat frame and backrest.
Permobil M1